Archives by: JMCristobal

JMCristobal

68 Posts 0 comments

About the author

JMCristobal Posts

STP – Timers, Port Roles and States

Enterprise Infrastructure
Choosing root ports Once the root bridge is chosen, a Root Port must be chosen for each switch, which is not the root bridge. The root port always ...
Read more 0

STP Overview

Enterprise Infrastructure
Spanning-Tree Protocol can exist between two devices (switches). Multiple active paths between devices cause loops in the network. STP is a layer 2 link management protocol that provides ...
Read more 0

Etherchannel PAgP y LACP

Enterprise Infrastructure
The audio of the video is only in Spanish EtherChannels can be negotiated between two switches; there are two protocols for this negotiation: PAgP and LACP. PAgP (Port ...
Read more 0

Etherchannel Overview

Enterprise Infrastructure
Etherchannel, also known as Link Aggregation, is a technology that allows grouping several physical interfaces that connect a pair of devices; when the etherchannel is established, the devices ...
Read more 0

VTP – VLAN Trunking Protocol

Enterprise Infrastructure
VTP uses Layer 2 trunk links to communicate VLAN information within a group of switches. VTP manages the addition, deletion, and renaming of vlan names by sending VTP ...
Read more 0

DTP – Dynamic Trunking Protocol

Enterprise Infrastructure
DTP is cisco’s proprietary protocol for negotiating trunking mode between two switches. A trunk link can only be negotiated between two switches if both belong to the same ...
Read more 0

VLANs y Trunk Ports

Enterprise Infrastructure
The video is in Spanish only Trunk ports can carry two or more VLANs over a single switch port and are helpful when switches are connected to other ...
Read more 0

VLANs y Access Port

Enterprise Infrastructure
The video is in Spanish only Virtual LAN – VLAN A VLAN defines a broadcast domain; they help us to create logical networks within the same switch with ...
Read more 0

UDLD – UniDirectional Link Detection

Enterprise Infrastructure
UDLD is a Cisco proprietary Layer 2 protocol that monitors the state of a port to validate bidirectional communication. Recall that each port in a switch is bidirectional, ...
Read more 0

LLDP – Link Layer Discovery Protocol

Enterprise Infrastructure
LLDP is similar to the CDP protocol but is based on the IEEE 802.1ab standard. The great advantage of LLDP is that it works on multi-vendor networks. Information ...
Read more 0

CDP – Cisco Discovery Protocol

Enterprise Infrastructure
CDP is a Cisco proprietary protocol used to collect information from devices on the network that is directly connected, such as hardware, software, device name and more. CDP, ...
Read more 0

Errdisable recovery

Enterprise Infrastructure
Switches can automatically detect error conditions on each of their ports. When an error is detected, the switch puts the port in “errdisable” state and is disabled. This ...
Read more 0

Managing MAC Addres Table

Enterprise Infrastructure
Switches operate at layer 2 of the OSI model (Data Link). It sends frames based on destination MAC addresses (Media Access Control) found within the same frame based ...
Read more 0

Basic information about my Fortigate unit

Basic information about my Fortigate unit
These days, I have had to configure and monitor some Fortigate equipment, most of it is done via GUI, but it is necessary and practical to use the ...
Read more 0

Macro switchport host – Cisco IOS

Enterprise Infrastructure
A few days ago, when I was configuring the ports of a switch and reviewing the operation of STP, I found in the CLI the command “switchport host”, ...
Read more 0
es_ES