firewall

firewall

Upgrade ASA an Active/Standby Failover Pair Using the CLI

Security
In this tutorial, we will update two ASA firewall 5585-X from CLI. Actual version 9.8.4.20Target version 9.8.4.44 Note: Perform these steps on the active unit Step 1 – ...
Read more 0

Configure SNMP on ASA Firewall

Security
SNMPv2 Specify the recipient of an SNMP notification, indicate the interface from which traps are sent, and identify the name and IP address of the NMS or SNMP ...
Read more 0

Configuring OSPFv2 on ASA Firewall

Security
Create an OSPF routing process: asa-jmcristobal(config)# router ospf process_id Define the IP addresses on which OSPF runs and the area ID for that interface: asa-jmcristobal(config)# network ip_address mask ...
Read more 0

Configure EIGRP on the ASA Firewall

Security
Create an EIGRP routing process asa-jmcristobal(config)# router eigrp as-num Configure the interfaces and networks that participate in EIGRP routing: asa-jmcristobal(config-router)# network ip-addr [mask] We can configure one or ...
Read more 0

Configure Default and Static Routes – ASA Firewall

Security
Configure a Default Route A default route is simply a static route with 0.0.0.0/0 as the destination IP address. ASA would be configured using the command route {nameif}. ...
Read more 0

Cisco ASA Remote Management – SSH/ASDM

Security
By default SSH, telnet or https management is disabled. First of all we must have configured the management interface of the equipment, something similar to: ASA-JMCristobal# sh run ...
Read more 0
en_US