Cisco

Cisco

Security

Configure EIGRP on the ASA Firewall

Create an EIGRP routing process asa-jmcristobal(config)# router eigrp as-num Configure the interfaces and networks that participate in EIGRP routing: asa-jmcristobal(config-router)# network ip-addr [mask] We can configure one or ...
Read more 0
Security

Configure Default and Static Routes – ASA Firewall

Configure a Default Route A default route is simply a static route with 0.0.0.0/0 as the destination IP address. ASA would be configured using the command route {nameif}. ...
Read more 0
Security

Configure SNMP for FTD

In this article we will configure the SNMPv3 protocol  on a Firepower Threat Defense through the FMC. The FMC and FTD have version 6.6.4.  Step 1 .- Select Devices > Platform Settings: ...
Read more 0
Security

Upgrade Firepower Threat Defense with FMC

Equipment to be used: FMC 2600 with version 6.6.4FTD 2130 with version 6.4.0.10 The objective is to upgrade the FTD to version 6.6.4 through the FMC. Before you ...
Read more 0
Security

Cisco ASA Remote Management – SSH/ASDM

By default SSH, telnet or https management is disabled. First of all we must have configured the management interface of the equipment, something similar to: ASA-JMCristobal# sh run ...
Read more 0
Enterprise Infrastructure

EIGRP

EIGRP (Enhanced Interior Gateway Routing Protocol) is an advanced vector distance protocol, an enhanced version by Cisco’s proprietary Interior Gateway Routing Protocol (IGRP). EIGRP uses the same algorithm ...
Read more 0
Enterprise Infrastructure

STP: Multiple Spanning-Tree

MST is a standard published by the IEEE to create different STP instances for groups of VLANs to have more than one STP topology approaching the Cisco mechanisms ...
Read more 0
Enterprise Infrastructure

STP: Rapid PVST+ configuration

The iEEE 802.1w standard was developed using the main concepts of 802.1d (Common Spanning-Tree) but with a faster convergence time. It can be applied to single or multiple ...
Read more 0
Enterprise Infrastructure

STP: Protection Features

Root Guard The Root Guard feature was developed as a means to control when a candidate root bridge switch connects to the network. It records the bridge ID ...
Read more 0
Enterprise Infrastructure

STP: Optimization methods

Some additional methods allow faster STP convergence if a link failure occurs. Portfast Allows fast connectivity on ports by immediately switching to the Forwarding state without going through ...
Read more 0
Enterprise Infrastructure

STP: PVST+ configuration

PVST+ (Peer-VLAN Spanning-Tree) First of all, let’s remember: Common spanning-Tree (CST) only handles one instance of STP on switches, based on 802.1Q trunks, by default over vlan 1 ...
Read more 0
Enterprise Infrastructure

STP – Timers, Port Roles and States

Choosing root ports Once the root bridge is chosen, a Root Port must be chosen for each switch, which is not the root bridge. The root port always ...
Read more 0
Enterprise Infrastructure

STP Overview

Spanning-Tree Protocol can exist between two devices (switches). Multiple active paths between devices cause loops in the network. STP is a layer 2 link management protocol that provides ...
Read more 0
Enterprise Infrastructure

Etherchannel PAgP y LACP

The audio of the video is only in Spanish EtherChannels can be negotiated between two switches; there are two protocols for this negotiation: PAgP and LACP. PAgP (Port ...
Read more 0
Enterprise Infrastructure

Etherchannel Overview

Etherchannel, also known as Link Aggregation, is a technology that allows grouping several physical interfaces that connect a pair of devices; when the etherchannel is established, the devices ...
Read more 0
en_US